Contact: Mr. Yang 📞 +86 134 7575 9568 Pioneer of domestic fluff pulp · The most complete fiber portfolio supplier

Home / Products / Blended Fluff Pulp

Softwood & Hardwood Blend

Engineered softwood and hardwood blends that hold performance where it matters and take cost out where it does not.

Fluff Pulp Family

Grade Overview

Scientific softwood/hardwood blending balances performance and cost — the value choice for mainstream volume production.

BlendedCost-effective
Request TDS & Samples
Blended Fluff Pulp

Application Areas

Mainstream Diapers

Volume tiers where performance targets are met without premium fiber cost

Feminine Care

Balanced softness, opacity and absorption for pads and liners

Pet Pads

Cost-driven absorbent products with defined capacity targets

Adult Incontinence

Mid-tier protection products with controlled cost per unit

Wet Wipes & Dry Wipes

Substrate blends tuned for softness and strength

General Absorbents

Industrial and household absorbent products

Product Specifications

Technical Point Typical Specification Buyer Benefit
Brightness 84–89 ISO Consistent white appearance across blend ratios
Moisture 7.0–9.0% Stable on standard hammermills
Freeness (CSF) 600–700 ml Adjusted to the blend ratio
Water Absorption 8.5–10.5 g/g Capacity tuned to the product target
Bulk 14–18 cm³/g Softwood share drives thickness retention
Fiber Length 2.0–2.8 mm average Controlled mix of long and short fiber
Blend Ratio Custom, typically 50/50 to 70/30 Cost and performance balanced to your specification
Sheet Form Jumbo reel or bale Custom widths on request

Typical ranges only. Blend ratios are agreed per project; batch-specific TDS is supplied with each shipment.

Detailed Product Description

The blend ratio is the whole design

Softwood contributes bulk, wet strength and network integrity. Hardwood and CMP contribute softness, opacity and lower cost. Moving the ratio by ten points changes thickness, absorption speed and unit cost in ways that are predictable once you have a baseline.

Start from the constraint that fails first. If cores collapse after packaging, increase the softwood share. If unit cost is the blocker, increase the hardwood or CMP share and re-test thickness. Do not change both at once.

Consistency is the hard part

A blend is only as consistent as its inputs. Batch-to-batch variation in either component shows up as drift in the finished core, which is why blends need a tighter specification on fines content and freeness than single-fiber grades.

Ask for the ratio and the tolerance on the ratio. “Blended pulp” without a stated ratio is not a specification — it is a description.

Validating a blend

Run the blend at the ratio you intend to buy, not at a convenient sample ratio. Measure thickness after compression, absorption rate at first and third wetting, and fines content. Three data points are usually enough to confirm whether the ratio is right or needs to move.

Frequently Asked Questions

Can you produce a specific blend ratio?
Yes. Ratios are agreed per project, typically between 50/50 and 70/30 softwood to hardwood or CMP.
How much cheaper is a blend than pure softwood?
It depends on the ratio and the component prices. Send us your target cost per tonne and performance floor, and we will propose a ratio.
Will a blend reduce core thickness?
Usually yes, because shorter fibers pack more densely. The amount depends on the ratio; it is predictable once you have a baseline.
Is the ratio guaranteed batch to batch?
Yes, within the tolerance stated in the purchase specification. We recommend specifying both the ratio and its tolerance.

Recommended Applications

Request TDS & Free Samples

Share your line specs and targets — grade-specific data sheet and samples within one business day