Application Areas
New Product Development
A fiber specification designed around a product that does not exist yet
Import Substitution
Replacing an imported grade with a domestic equivalent, validated on your line
Cost Reduction
Re-specifying an existing SKU to hit a lower unit cost without losing performance
Line Matching
Fiber tuned to the constraints of a specific hammermill and forming section
Performance Upgrades
Targeted improvement in bulk, absorption speed or wet strength
Supply Security
A second qualified specification for an existing product
Customization Dimensions
| Technical Point | Typical Specification | Buyer Benefit |
|---|---|---|
| Fiber Blend | Softwood / hardwood / bamboo / CMP / reed in any workable ratio | Performance and cost balanced to your target |
| Brightness | 70–90 ISO depending on blend | Matched to product appearance requirements |
| Freeness | Adjusted within the blend’s range | Tuned to your hammermill and forming setup |
| Debonding System | Cationic, non-ionic or composite | Balances bulk against absorption speed |
| Sheet Weight & Width | Custom per reel | Fits your unwinding and feeding equipment |
| Processing Grade | Unprocessed, semi-processed or fully processed | Controls how much fiberization you do in-house |
| Moisture Target | Set within 6.5–9.5% | Matched to your line humidity and storage conditions |
| Packaging | Bale, reel, wrap specification | Matched to your climate and handling |
Every custom specification is documented in a project TDS before production, and validated with samples before the first commercial order.
How a Development Project Runs
1. Define the target
We start with numbers: product type, basis weight, target thickness after compression, absorption rate at first and third wetting, fines ceiling, unit cost ceiling, and the constraints of your hammermill. Without these, “custom” becomes guesswork.
2. Propose a specification
Based on the target we propose a fiber blend, a debonding system and a processing grade, and explain the trade-offs. You get the reasoning, not just a number.
3. Sample and validate
Samples are produced to the proposed specification and run on your line. We support the trial and record the parameters that changed, so the result is repeatable rather than a one-off.
4. Lock the specification
Once the trial passes, the specification is documented with tolerances and becomes the reference for every subsequent batch. Changes require a new validation — no silent substitutions.
The most common reason custom projects stall is an undefined target. “Better than what we have now” is not a specification; “thickness ≥ 14 mm after compression at 12 g basis weight” is.