Application Areas
Mainstream Diapers
Volume tiers where performance targets are met without premium fiber cost
Feminine Care
Balanced softness, opacity and absorption for pads and liners
Pet Pads
Cost-driven absorbent products with defined capacity targets
Adult Incontinence
Mid-tier protection products with controlled cost per unit
Wet Wipes & Dry Wipes
Substrate blends tuned for softness and strength
General Absorbents
Industrial and household absorbent products
Product Specifications
| Technical Point | Typical Specification | Buyer Benefit |
|---|---|---|
| Brightness | 84–89 ISO | Consistent white appearance across blend ratios |
| Moisture | 7.0–9.0% | Stable on standard hammermills |
| Freeness (CSF) | 600–700 ml | Adjusted to the blend ratio |
| Water Absorption | 8.5–10.5 g/g | Capacity tuned to the product target |
| Bulk | 14–18 cm³/g | Softwood share drives thickness retention |
| Fiber Length | 2.0–2.8 mm average | Controlled mix of long and short fiber |
| Blend Ratio | Custom, typically 50/50 to 70/30 | Cost and performance balanced to your specification |
| Sheet Form | Jumbo reel or bale | Custom widths on request |
Typical ranges only. Blend ratios are agreed per project; batch-specific TDS is supplied with each shipment.
Detailed Product Description
The blend ratio is the whole design
Softwood contributes bulk, wet strength and network integrity. Hardwood and CMP contribute softness, opacity and lower cost. Moving the ratio by ten points changes thickness, absorption speed and unit cost in ways that are predictable once you have a baseline.
Start from the constraint that fails first. If cores collapse after packaging, increase the softwood share. If unit cost is the blocker, increase the hardwood or CMP share and re-test thickness. Do not change both at once.
Consistency is the hard part
A blend is only as consistent as its inputs. Batch-to-batch variation in either component shows up as drift in the finished core, which is why blends need a tighter specification on fines content and freeness than single-fiber grades.
Ask for the ratio and the tolerance on the ratio. “Blended pulp” without a stated ratio is not a specification — it is a description.
Validating a blend
Run the blend at the ratio you intend to buy, not at a convenient sample ratio. Measure thickness after compression, absorption rate at first and third wetting, and fines content. Three data points are usually enough to confirm whether the ratio is right or needs to move.